Nearly all of the time, businesses will spend a lot of money to buy their lift trucks. It is vital, therefore to take proper care of your equipment to protect your investment into the long run. It is a great idea to know the procedures which are undertaken in taking care of and maintaining this machine.
By starting up the forklift and listening carefully how it works is among the best ways to tell how good the engine is performing. Like for instance, if there are any misses or knocks, the machinery is defective and this must raise some issues. Moreover listen closely for any squealing sounds which come from the belts because these noises will provide you with a lot of information.
When carrying out maintenance, some of the main components you would have to pay attention to consist of the safety warning devices, horn, the lights, the gauges and the overhead guard. Any burnt out light bulbs or faulty parts must be replaced as soon as they are noticed. It is also vital to check the wiring.
The battery compartment terminals must be cleaned after the above components have been inspected carefully. If the terminals are not clean, be sure to clean them properly. Every battery cell should be inspected in order to make certain that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the equipment and then change the filters. The fuel filters, hydraulic filter and the transmission filter should be replaced on a regular basis. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change has been completed and new filters have been fitted, visually check the drive axle from underneath the equipment. Be sure to grease the axle if there is any grease fitting. Inspect the belts on the engine for any cracks or frays. If you find any, fix the issue accordingly. Next, check every other component of the equipment like the wheels. If any type of fault or problem is detected, be sure to address it immediately so as to make certain the machine is running at its safest and optimum levels.