Change a Propane Tank
Propane fueled forklifts are commonly used in warehouses. The forklift is made with the propane tank mounted at the back of the operator. The tanks, that look much like beer kegs, have to be replaced periodically since they have a limited lifespan. Forklift operators must utilize caution when handling propane tanks. Compressed gases are hazardous, particularly since the gas is flammable. Utilize care when removing and replacing propane tank to prevent being injured.
1 To change a propane tank, first stop the lift truck while leaving the engine running, and turn the valve on the tank off. Let the lift truck run until the engine dies. This procedure burns the gas off inside the transfer hose which connects the engine and the tank. Before taking the next steps, wear the proper safety equipment, such as insulated gloves made of either neoprene or leather. It is very important for you to protect your skin from touching the compressed gas, which is very cold.
2 Disconnect the hose from the tank and take the holding straps off to remove the tank. When you put in a new tank, reconnect the holding straps and reattach the hose at the valve of the tank by tightening the nut.
3 Leaks could be checked just by applying soapy water to the valve and slightly opening it. If there is a leak, it will cause bubbles to foam from around the valve. If this happens, check the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks around the valve area, and afterward perform the leak inspection procedure once more. Persistent leaks mean that the nut and connecting hose would have to be replaced. Nonetheless, if replacing the nut and hose still does not stop the leak, the tank should be replaced.
4 Lastly, open the valve all the way to allow the gas to fill the connecting hose. Afterward you could start the lift truck and continue operating.